Doyon JAOP6 Bedienungsanleitung PDF herunterladen (Seite 37)

A-34

Uneven baking.

Make sure that the grills do not obstruct the air flow. Do not use

foil on the grills.

Verify the temperature of the oven by using an oven thermometer

and make sure that it is even with the thermostat setting.

If the oven is baking too much on the sides, it is possible that the fan

is not cycling properly. Verify if the motor turns 2.5 minutes in a

direction, stops 30 seconds and starts for 2.5 minutes in the opposite

direction.

The steam works in the oven but the

light inside the steam button does not

lite.

Replace the inside button bulb light.

If steam device of the oven does not

work properly.

The oven must have been heating for at least half an hour before

you use the steam system. If not, water will appear at the bottom of

the oven.

Check if the water supply valve (of the building) is open.

Check if the water needle valve (of the oven) is open one eighth of a

turn. Just close it and open it one eighth of a turn maximum.

Check the solenoid valve.

Check the preset steam timer in the back control box.

Be sure to inject steam while the fan is running.

The steam button light should lite during the steam injection.

If the OVERHEAT WARNING light

is on, and you hear the warning

buzzer.

Check if the cooling fan airflow is not obstructed.

Check the cooling fan if it is running. If not, call a qualified

technician to replace it.

(Electrical components may be damaged if it is not repaired

immediately.)

OPTIONAL

Manual fill water pan.

The warning red light in the front

control panel stays on when the

water pan is full.

You have no more water in the principal water pan.

Check if the water line is not in air lock condition. Disconnect the

water line at the inlet of the green solenoid valve and clean the

strainer filter.

Also clean the principal water pan and the float switch.

If there is no light in the proofer.

1. Verify every breaker in front of the proofer.

2. Verify the main proofer switch and the main proofer contactor.

If there is no heat in the proofer.

1. Verify every breaker in front of the proofer.

2. Verify whether the pilot light will function by raising the

thermostat to a higher setting. If yes, verify element. If not,

verify pilot light, thermostat or contactors.

If there is no humidity in the proofer.

Verify whether the pilot light works when you increase the humidity

to the position high. If yes, verify if water comes in the reservoir

and check the water level switch box and the float switch. Verify if

limestone obstructs the waterflow. If the float switch is working

fine, verify the contactor P1 and the immersion element. If the pilot

light does not lite, verify the pilot light and the infinite switch.

Do not allow any obstruction to free the airflow of the burner.

CAUTION

Never try to modify the burner controls.

This must be done only by a qualified technician and under the company's instructions.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare

Doyon JAOP6 Bedienungsanleitung Seite 37

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ofen Doyon JAOP6